Aluminium scrap
Extrusion, taint tabor, used beverage cans, radiators, sheets, foil, wire, wheels, castings, turnings and profiles.
What we accept
Extrusion, taint tabor, used beverage cans, radiators, sheets, foil, wire, wheels, castings, turnings and profiles. Eleven forms, each graded on its own.
Extrusion and profile are the cleanest streams
Clean extrusion and profile off a fabrication shop grade above mixed or painted sheet. Keeping a fabrication stream separate from general aluminium is what protects its grade.
Castings, wheels and turnings
Cast aluminium, wheels and turnings are taken as their own grades. Turnings in particular are assessed on what they carry with them rather than on weight alone.
Extrusion is the clean end
Clean extrusion free of thermal break, rubber and screws is the highest grade. Painted and coated sheet, cast, and mixed alloy run below it and are weighed as separate streams.
Attachments and alloy type
Steel screws, hinges, rubber gasket and plastic thermal break are stripped out. Cast and wrought aluminium are kept apart because they are remelted into different products.
From the yard to the port
Five stages, handled by us, in the order they happen.
- 01
Grading and preparation
Material is sorted and graded, then cut, sheared or baled to the size the buyer specifies.
- 02
Weighing
Every load is weighed and a weight ticket is issued against it, recording gross, tare and net.
- 03
Inspection
A lot may be inspected at the yard by arrangement. Photographs and weights of a specific lot are provided on request.
- 04
Container loading
Sorted material is loaded to container at the yard, grade by grade rather than mixed.
- 05
Documentation and shipment
Paperwork is handled from the yard through to the port, and the shipment leaves through Shuaiba or Shuwaikh.
Submit an enquiry
Enquiries for disposal contracts and material purchases are handled from the same office. Documentation is provided on request.
Every enquiry is answered within 24 hours